Please read these instructions carefully before using this product, and save this manual for future use.

E-Series HMI

- 2 -

1.1 Features - 8 -

1.2 Package Contents - 9 -

1.3 Product Overview - 10 -

2.3 Changing Serial Port Settings - 17 -

2.4 How to Enable Watchdog - 18 -

2.5 Turning off Your Device - 19 -

3.1 Wiring Requirements - 20 -

3.2 Mounting Solution - 21 -

- 3 -

This device complies with part 15 FCC rules.

Operation is subject to the following two

conditions:

interference.

received including interference that may cause

commercial environment. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment

in a residential area is likely to cause harmful interference in which

case the user will be required to correct the interference at him

own expense.

- 4 -

European Union

- 5 -

Copyright Notice

No part of this document may be reproduced, copied, translated, or

transmitted in any form or by any means, electronic or mechanical, for

any purpose, without the prior written permission of the original

manufacturer.

Trademark Acknowledgement

Brand and product names are trademarks or registered trademarks of

their respective owners.

Disclaimer

Winmate Inc. reserve the right to make changes, without notice, to

any product, including circuits and/or software described or contained

that are described in this manual are for illustration purposes only. We

make no representation or guarantee that such application will be

suitable for the specified use without further testing or modification.

Warranty

Winmate Inc. warranty guarantees that each of its products will be

free from material and workmanship defects for a period of one year

from the invoice date. If the customer discovers a defect, we will, at

his/her option, repair or replace the defective product at no charge to

the customer, provide it is returned during the warranty period of one

year, with transportation charges prepaid. The returned product must

For example, the serial number 1W14Axxxxxxxx means October of

year 2014.

- 6 -

Customer Service

We provide a service guide for any problem by the following steps:

First, visit the website of our distributor to find the update information

about the product. Second, contact with your distributor, sales

representative, or our customer service center for technical support if

you need additional assistance.

You may need the following information ready before you call:

In addition, free technical support is available from our engineers

- 7 -

Safety Information

information applications

E-Series HMI uses HDMI1.4a connector to connect to the external

display.

CEC

14

Hot Plug Detect

485. Jumpers are located on the motherboard. You need to

open the housing in order to access the jumpers.

cap is placed on both pins, the jumper is SHORT. The

illustration below shows a 3-pin jumper; pins 1 and 2 are short.

If you remove the jumper cap, the jumper is OPEN.

The picture below shows RS-232/422/485 (J8/J9) jumper setting.

utility. Find more information on Watchdog in “Watchdog Guide” that

you can download from Winmate Download Center or File Share.

To enable watchdog in Watchdog AP follow the instructions below:

separately.