La page est en cours de chargement...
SPECIFICATIONS
HAZARD DEFINITIONS
INTRODUCTION
SAFETY
WARNING! Read and understand all instructions before
using this tool. The operator must follow basic
precautions to reduce the risk of personal injury
and/or damage to the equipment.
WORK AREA
PERSONAL SAFETY
WARNING! Wear personal protective equipment
approved by the Canadian Standards Association (CSA)
or American National Standards Institute (ANSI).
PERSONAL PROTECTIVE EQUIPMENT
PERSONAL PRECAUTIONS
WARNING! Spray materials, solvents and other
materials can be harmful if inhaled or come in contact
with the body.
SPECIFIC SAFETY PRECAUTIONS
WARNING! DO NOT let comfort or familiarity with
product (gained from repeated use) replace strict
adherence to the tool safety rules. If you use this tool
unsafely or incorrectly, you can suffer serious personal
injury.
VIBRATION PRECAUTIONS
POWER CORD
WARNING! Electric shocks can cause severe injury.
EXTENSION CORDS
Cord Type
Up to 5 Metres
From 5 to 10 Metres
FIRE AND EXPLOSION PRECAUTIONS
WARNING! Vapours from paint and solvents can be
flammable. Their presence in the work area create an
ignition hazard.
UNPACKING
WARNING! Do not operate the tool if any part is
missing. Replace the missing part before operating.
Failure to do so could result in a malfunction and
personal injury.
ASSEMBLY & INSTALLATION
OPERATION
PREPARING PAINT/MATERIAL
WARNING! Do not use materials with a flashpoint
higher than 60°C (140°F).
NOTICE! Certain paints/materials may need to be
thinned before operation. Always use a proper thinner
as recommended by the manufacturer of the
paint/material.
Spray Material
Runout Time
Action
FILLING THE CANISTER
ADJUSTING THE SPRAYER
NOZZLE
FLOW
PAINTING
CARE & MAINTENANCE
WARNING! Only qualified service personnel should
repair the tool. An improperly repaired tool may
present a hazard to the user and/or others.
FILTER
WARNING! Never operate the
power unit without the filters in
place.
CLEANING
LUBRICATION
NOTICE! NEVER use a penetrating oil to
lubricate the tool. Penetrating oil may
act as a solvent that can break down
the grease and cause the tool to seize
up.
STORAGE
DISPOSAL
TROUBLESHOOTING
Problem(s)
Possible Cause(s)
Suggested
Solution(s)
PARTS BREAKDOWN
PARTS LIST
#
DESCRIPTION
/