17
• Fill the food to the beaker (not more than the maximum indicated
level).
• Plug in, hold the power handle steady. Switch the appliance on by
pressing the switch button. (the marking of “I” is for the lower speed, “II”
for the higher speed.)
• Immerse the blade guard completely in the ingredients.
• Blend the ingredients by moving the appliance slowly up and down and
in circles.
• After you have completed blending, Release the switch button, then
unplug from outlet.
• Warning: The continuous operating time must be less than 10 seconds.
Never blend hot oil, fat or meat.
• If your blender gets blocked, rst stop and unplug before clearing.
• After use, unplug and dismantle. The dismantlement is the reverse of
assembly.
• Always switch off and unplug before cleaning. Please refer to the
instruction in the “care and cleaning”.
To use the chopper
• Remove the protective cover from the blade of the chopper.
• Clean the lid, blade unit and bowl of the chopper.
• Fix the blade unit in the chopper bowl.
• Fill the food to the bowl (not more than the maximum indicated level).
• Fit the power handle inside the chopper, turn and lock until you hear
a slight click. The marks on the power handle and the chopper should
now be aligned with each other. If this is the case, the chopper is
locked correctly.
• Check if the power cord is not damaged.
• Make sure your electricity supply is the same as the one shown on the
power handle.
• Plug in, hold the power handle steady. Switch the appliance on by
pressing the switch button. (the marking of “I” is for the lower speed, “II”
for the higher speed.)
• After you have completed blending, Release the switch button, then
unplug from outlet.
• Warning: The continuous operating time must be less than 30 seconds.
• If your chopper gets blocked, rst stop and unplug before clearing.
• After use, unplug and dismantle the power handle and the lid unit in
sequence, take the blade out of the bowl by holding the plastic shaft,