Philips HR2355/08 Manuel utilisateur

HR2355/08

Always there to help you

Register your product and get support at

www.philips.com/welcome

Question?

Contact

Philips

EN User manual 3

ES-AR Manual del usuario 26

FR-CA Mode d'emploi 50

2 English

Congratulations on your purchase, and welcome to Philips!

To fully benet from the support that Philips offers, register your product at

www.philips.com/welcome.

Read this user manual carefully before you install and use the unit. Save it for future

reference.

What's in the box

Shaping

discs

Cleaning tools

Lasagna/

Dumpling

Penne

Fettuccine

Water cup

User manual Recipe book

Main unit

Flour cup

Flat cleaning tool

Use the at

cleaning tool

Use the at

cleaning tool

Spaghetti

Assembled

on the

appliance

upon

purchanse

English 3

Contents

What's in the box �� 2

Important �� 4

Overview �� 8

Disassembling and cleaning before

rst use �� 10

Assembling �� 12

Using the pasta maker �� 14

Cleaning �� 20

Troubleshooting �� 23

Product information �� 25

Recycling �� 25

Guarantee and service �� 25

4 English

Important

• Before you connect the appliance to the power, make

sure that the voltage indicated on the bottom of the

appliance corresponds to the local power voltage.

• Make sure that your hands are dry before you insert the

plug into the power outlet.

• Make sure that the plug is firmly inserted into the power

outlet.

• Never connect this appliance to a timer switch.

• Before you insert the plug into the power outlet, make

sure that the appliance is assembled correctly.

• If the power cord, the plug, or other parts are damaged,

do not use the appliance.

• If the power cord is damaged, you must have it replaced

by Philips, a service center authorized by Philips or

similarly qualified persons to avoid a hazard.

• Do not replace parts of the appliance yourself.

Warning

Safety

• Read this user manual carefully before you use the appliance,

and save it for future reference.

English 5

Warning

• This appliance shall not be used by children. Keep the

appliance and its cord out of reach of children.

• This appliance can be used by persons with reduced

physical, sensory or mental capabilities or lack of

experience and knowledge if they have been given

supervision or instruction concerning use of the

appliance in a safe way and if they understand the

hazards involved.

• For their safety, do not allow children to play with the

appliance.

• To prevent any accidents, do not use the appliance if it is

damaged for any reason.

• Always disconnect the appliance from the supply if it is

left unattended and before assembling, disassembling or

cleaning.

• Switch off the appliance and disconnect from supply

before changing accessories or approaching parts that

move in use.

6 English

• Before using the appliance for the first time, disassemble

and wash the accessories thoroughly (see “Disassemble

and cleaning before first use” section.)

• The appliance is intended for household use only.

• Do not use this appliance on an unstable or uneven

surface.

• Do not disconnect the power cord before processing is

complete. If you have to stop processing, disconnect the

power cord before you perform other operations.

• To better protect the lifetime of the appliance, we

recommend the continuous working time to be less

than 45 minutes. You can restart using the appliance after

15 minutes.

• If you intend to use the appliance continuously, clean the

shaping disc with the supplied cleaning tool each time

after use. For cleaning ease, do not soak the shaping disc

into the water directly.

• Do not bend the power cord forcibly, jerk, twist, bundle

nor put under heavy items.

• Do not put metal or flammable objects in the mixing

chamber.

• Unplug the appliance when not in use.

• Do not use the appliance near flammable objects such as

table cloth or drapes.

Caution

English 7

Caution

• Pull out the power plug immediately when you detect

smoke.

• When unplugging the power cord, do not pull the cable

but grab the plug part.

• Keep the power plug clean.

• Do not put heavy objects on the appliance.

• This appliance is designed as consumer kitchen appliance.

Do not use for any other purpose

• Do not move the appliance while it is operating.

• Disconnect the power and remove the power cord

before cleaning or disassembling this appliance.

• Do not immerse the main unit in water.

• Place the appliance in a dry and well ventilated place

after use.

• To prevent a short circuit or an electric shock, do not

pour water or any liquid into the safety switch.

• Do not use a dishwasher to clean the machine or the

accessories.

EMF

This Philips appliance complies with all applicable standards and regulations regarding

exposure to electromagnetic elds.

8 English

Overview

Mixing

chamber lid

Disc holder Front panel

Front panel

knobs

Shaping discsDisc holder

safety switch lever

Mixing

chamber

Mixing

paddle

English 9

Control panel

display

Power cord

Main unit

Disc holder safety switch

Shaping discs storage

Safety switch hole of

the mixing chamber lid

Power on/

off button

Program

button

Display

screen

Servings

button

Start/pause

button

Program button - select the extrusion-only program

or automatic program .

Servings button - select

to make ~ 300g, 1-2

servings or

to make ~ 600g, 3-4 servings of fresh

pasta.

Abbreviations

g = grams

~ = approximately

ml = milliliters

mm = millimeters

kg = kilogram

in = inch

10 English

Important

1

Remove the mixing chamber lid from the

appliance.

2

Loosen the front panel control knobs.

Note:

• The front panel is heavy. Take extra caution when

removing it.

Disassembling and

cleaning before

rst use

• Before using the appliance for the first time, remove and safely discard any

packaging material and /or promotional labels.

• Take out all the parts and accessories, wash and thoroughly dry all parts and

accessories (see "Cleaning" section).

• Do not use water to rinse or soak the main unit.

• Do not use a scourer or similar cleaners as these will scratch the plastic surface

and affect the lifetime of the pasta maker.

• This appliance is intended for household use only.

English 11

3

Disassemble the front panel, the shaping disc, the shaping disc holder, the mixing

paddle, and the mixing chamber in order.

4

Clean all detachable parts, and wipe them dry.

2

3

4

5

1

12 English

Important

Assembling

Follow below assembling steps to install

the pasta maker.

1

Push the mixing chamber into the appliance.

2

Point the mixing paddle to the hole in the main

unit. Insert the mixing paddle all the way into the

main unit.

3

Attach the disc holder onto the appliance.

Disc holder safety switch

Disc holder safety switch lever

Note:

• Check that the safety switch and safety

switch lever are set as shown in the

illustration to the right.

1

2

• Make sure to tighten the front panel knobs during assembly.

• Make sure the appliance is not plugged in when assembling the appliance.

English 13

4

Put the shaping disc onto the disc holder ❶ , and make sure it is rmly xed on the

disc holder .

Note:

• Make sure the inner cavity

of the shaping disc and

disc holder is properly

tted.

5

Attach the front panel to the main unit.

Disc holder safety switch lever

Note:

• Make sure the front panel is completely fastened

before using the appliance.

• The front panel is heavy. Take extra caution when

assembling it.

6

Fasten the front panel control knobs.

Note:

• If the front panel or the shaping disc is not properly

assembled, the safety switch will prevent the

appliance from working.

7

Close the mixing chamber lid properly.

Note:

• If the mixing chamber lid is not properly installed,

the safety switch will prevent the appliance from

working.

1

2

1

2

14 English

Important

Using the pasta

maker

Preparing the ingredients

1

Measure one full cup of flour. Scrape off any

excessive flour from the cup edge with the

supplied flat cleaning tool. One full cup is

equivalent to 1-2 servings.

Note:

• Do not shake or hit the our cup to remove

excessive our. This will affect the our weight.

You can also use a kitchen scale to measure the

our. For instance, ~250g our makes

approximately 1-2 servings; ~500g our makes

approximately 3-4 servings of fresh pasta.

• Make sure to follow the right order to add flour and water into the mixing

chamber. Put the flour into the mixing chamber first, then place the chamber lid

onto the chamber. Start the pasta maker, and then slowly pour water along the

entire length of the opening in the lid.

• Never put excessive ingredients into the pasta maker. Otherwise, it will damage the

appliance. The maximum amount of flour used for each batch is 500g.

• Do not put any ingredients that are 60°C / 140°F or above into the pasta maker,

nor place the pasta maker in surroundings with high temperature (60°C / 140°F),

for instance in a high temperature sterilization. This will deform the appliance.

• Never pour water into the mixing chamber before you place the chamber lid onto

the chamber. Do not pour any liquids into the safety switch hole.

• Do not pour water into the mixing chamber before turning on the pasta maker.

Follow the instruction carefully to enjoy homemade pasta.

English 15

2

Remove the chamber lid.

3

Pour the our into the chamber. If you want to

make 3-4 servings, add a second cup of our as

you will need 2 cups (~500g) of our in total.

4

Close the chamber lid properly.

Note:

• Insert the two hooks into the appliance rst , and

then push the lid against the main unit .

• The appliance will not start working if the chamber

lid is not properly closed. During the pasta making

process, if the chamber lid becomes loose, the

appliance will automatically stop working.

5

Use the “Pasta making recipe table” and measure

the required amount of water.

Note:

• Do not pour water into the mixing chamber before

turning on the pasta maker.

• There are 2 sets of water markings on the supplied

water cup. One set is for normal pasta making, and

the other set is for egg pasta and other avor pasta

making.

1

2

16 English

Pasta making recipe table

For more information, you can visit www.philips.com/kitchen.

Flour/water ratio table

Flour

Normal pasta Egg pasta

Processing

time

Output

Water (marking)

Water + egg

mixture (marking)

1 our cup

(~250g)

Amount of water

needed for a cup

of our (~90ml)

Amount of water

+ egg mixture

needed for a cup

of our (~95ml)

10 minutes

~ 300g fresh

pasta.

This is sufcient

as a main meal

for 1-2 persons,

or as a side dish

for 4-6 persons.

2 our cups

(~500g)

Amount of water

needed for 2 cups

of our (~180ml)

Amount of water

+ egg mixture

needed for 2 cups

of our (~190ml)

15 minutes

~ 600g fresh

pasta.

This is sufcient

as a main meal

for 3-4 people, or

as a side dish for

8-10 people.

English 17

Note:

• To ensure the quality of the pasta, use gluten our to make pasta. Follow the

recommended proportion to add the ingredients.

• Seasonal changes and using ingredients from different regions may affect the our/

water ratio. You may adjust based on the recommended proportion.

• When making the egg pasta or vegetable pasta, make sure you whisk the egg

mixture or vegetable juice evenly with the water before pouring into the chamber.

When adding ingredients, make sure the ingredient is in a liquid form.

• See the recipe book provided for additional pasta recipe variations and many

delicious new recipes to try.

Important

• The pasta recipes provided in the user manual and recipe book have been

tested for success. If you experiment with or use other pasta recipes, the flour

and water/egg ratios will need to be adjusted to the flour and water cup ratios

included with the pasta maker. The pasta maker will not operate successfully

without adjusting the new recipe accordingly.

18 English

Selecting the pasta making program

1

Connect the power plug to any 220-240V AC

outlet. The pasta maker will sound once, and all

indicators will flash once. Press the power on/off

button to switch on the pasta maker.

2

Based on the amount of our, press the servings

button

to select to make ~ 300g or

to make ~ 600g of fresh pasta.

Important

• Do not select the extrusion-only program before the dough mixing is complete.

Otherwise, this will damage the pasta maker and its lifetime.

• Do not disconnect the power cord before processing is complete. If you have to

stop processing, press the on/off button

to turn off the pasta maker and then

disconnect the power cord from outlet before performing other operations.

• To better protect the lifetime of the appliance, it is recommended the continuous

working time be less than 45 minutes. You can restart using the appliance after a

15 minute rest.

• If you intend to use the appliance continuously, clean the shaping disc with the

supplied cleaning tool each time after each pasta making session. For cleaning

ease, do not soak the shaping disc directly in water.

English 19

3

Press the start/pause button to start

processing, and the processing time starts to

count down.

Note:

• By default, the program is set as automatic. If this is

not the case, press the program button

to re-

select.

4

After the kneading starts, slowly pour in the

water or water + egg mixture along the entire

length of the slot in the lid.

Note:

• During dough mixing, do not add other ingredients

after you have poured in the water. Otherwise, it will

affect the results of the pasta texture.

5

The pasta will start extruding out after a few

minutes. Place a container right under the outlet.

Cut the pasta into the desired length with the

supplied cleaning tool.

Note:

• If you notice the program is not set as automatic

while pasta is extruding, press the start/pause button

to stop the program. Then, press the power on/

off button and disconnect the plug from the

power socket. After cleaning the shaping discs, you

can restart the process.

• If the ratio of liquid and our is not correct, the extrusion will not succeed. In this

case, prepare the ingredients again.

• Move the cleaning tool downwards to cut the pasta.

6

After the pasta making is complete, if you notice there is some leftover dough inside

the chamber, you can press the extrusion-only button

and press the start/pause

button for extra extrusion.

Note:

• The countdown timer of the extrusion-only program is 3 minutes.

• You may nd some ne pasta threads on the pasta surface. This is normal.

• The cooking time of the pasta varies depending on personal preferences, pasta

shapes, and number of servings.

20 English

Important

1

Press the power on/off button to turn off the

pasta maker, and then disconnect the plug from

the power outlet.

2

Remove the chamber lid from the appliance.

Cleaning

• Disconnect the power and remove the power cord before cleaning or

disassembling this appliance.

• Do not immerse the main unit in water.

• Do not use a scourer, caustic cleaners, or abrasive cleaners (for examples,

gasoline, alcohol, and propanol) to clean the appliance.

• Clean the appliance each time after use, or the appliance might not operate properly.

• Take extra caution when cleaning the appliance to avoid getting cut by any sharp

edges.

La page charge ...

Philips HR2355/08 Manuel utilisateur

Philips HR2355/08 Manuel utilisateur

dans d''autres langues

Documents connexes

Autres documents