NOMA iQ Battery-Operated Smart Wi-Fi Flood & Water Leak Sensor Le manuel du propriétaire

Marque: NOMA iQ

Modèle: Battery-Operated Smart Wi-Fi Flood & Water Leak Sensor

Taper: Le manuel du propriétaire

USER MANUAL

READ AND SAVE THESE INSTRUCTIONS

SMART WI-FI WATER LEAK SENSOR

046-3370-2

TABLE OF CONTENTS

WHAT’S IN THE BOX

INSTALLATION

SPECIFICATIONS

WARNINGS

BATTERY REPLACEMENT

WARRANTY

WHAT’S IN THE BOX

01.

02.

03.

04.

SMART WATER SENSOR

MOUNTING ACCESSORIES

HOLDER & PROBE

1 X BATTERY

01 02 03 04

CR2-3V

probe

main body

holder LED indicator light

•

INSTALLATION

When you select your mounting location, make sure the surface area

is clean.

During the mounting process, ensure the metal contacts on the probe

are facing downwards.

Remove the holder from the main body. Select your location and mount

the holder using the included screw and wall anchor, or using the

adhesive mount. Once installed, insert the main body and plug in the

probe.

Once the main body has been placed in its intended location, place the

probe where a potential leak may occur.

Note: Once your water sensor has been connected to the NOMA iQ app,

make sure to check that the sensor is working by placing the probe in

water. The sensor should light up and make a sound as it detects water,

and you should receive a notiﬁcation on your mobile phone that a leak

is detected.

• Remove the holder from the main body. Twist the top half of the

sensor counter-clockwise. Once the casing is o, remove the small

plastic tab on the battery terminal. The battery will be connected and

the sensor will automatically be in pairing mode.

• If not in pairing mode, press and hold the power/reset button for 5

seconds until ﬂashing slowly. Then release the button and the

sensor will enter pairing mode.

• In order to pair the device, please enable and give permission for

Location Services and Bluetooth on your mobile device. In the NOMA

iQ app, select the “+” symbol in the top right-hand corner. Select the

device and follow the instructions within the app.

MOUNTING INSTRUCTIONS

LEAK DETECTION

When the probe detects water, the sensor will beep for an interval of 2 minutes and

you will get a notiﬁcation from the NOMA iQ app. If the leak is not cleared within this

time frame, the sensor will go into sleep mode for about 2 hours in order to conserve

the battery. This cycle will continue until the leak is removed.

If the device will be installed outside of audible range, please ensure to connect your

sensor to the NOMA iQ app to receive notiﬁcations/alerts. Please also ensure to turn

on notiﬁcations on your mobile phone.

Disclaimer:

Users purchasing this product, please read this statement carefully. There are certain

risks associated with using the Smart Wi-Fi Water Leak Sensor, and users should fully

understand the performance and risks of the product and bear their own responsibilities.

NOMA iQ and Canadian Tire Corporation, Limited have strictly inspected and controlled

the quality of this product in accordance with national standards and regulations during

the production process. However, due to factors such as usage environment and user

operation, the product may encounter problems and even result in property damage

to users. NOMA iQ and Canadian Tire Corporation, Limited do not assume any liability

for compensation for losses caused by any reason, including losses caused by product

issues.

When a user purchases this Smart Wi-Fi Water Leak Sensor, it is deemed that they have

fully understood the performance, risks, and usage requirements of the product, and

assume their own responsibility. NOMA iQ and Canadian Tire Corporation, Limited

reserve the right to make technical improvements and upgrades to the product. During

use, users should comply with the requirements of the product manual and

safety operating procedures.

This disclaimer aims to clarify the rights and responsibilities of both parties and avoid

potential disputes and controversies.

Before using the Smart Wi-Fi Water Leak Sensor, users must carefully read this statement

and make their own decision on whether to make use of the product or not.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

READ ALL INSTRUCTIONS BEFORE USE.

SPECIFICATIONS

• Required battery: 1x CR2-3V

• Standby current: 13 μA

• Working current: 100 mA–110 mA

• Wireless type: 2.4 GHz

• Wireless range: 148” (45 m)

• Wireless Protocol: IEEE 802.11b/g/n

WARNING

• WARNING - To reduce the risk of ﬁre, electric shock, or serious personal injury:

• Do not immerse or expose the main body in/to water or other liquids.

• Do not ingest or swallow the battery

• This product is not intended for use by children and contains small parts that may

pose a choking hazard to children under the age of three. Keep the product out of

the reach of children and pets.

• NOMA iQ and Canadian Tire Corporation, Limited disclaims all liability for any

water damage that occurs as a result of failure of this product to properly function

WARNING:

Keep batteries away from children and pets.

• Follow the battery manufacturer’s safety and usage instructions.

• Insert the battery observing the proper polarity (+/-) as indicated inside the

battery compartment.

CAUTION:

Failure to properly align the battery polarity can cause personal injury and/or

property damage.

• Remove a spent or discharged battery from the product. Remove the battery

when not using the product for an extended period.

• Never throw batteries into a ﬁre. Do not expose batteries to ﬁre or other heat

sources.

DISPOSAL OF USED BATTERIES:

Battery may contain hazardous substances which could endanger the environment

and human health. Used batteries shall not be treated as municipal waste, but

left at the appropriate collection point for recycling. For more information about

collection and recycling of used batteries, please contact your local municipality or

waste disposal service.

• Use type CR2-3V battery.

• Install only new batteries of the same type in your product.

• Failure to insert batteries in the correct polarity, as indicated in the battery

compartment, may shorten the life of the batteries or cause batteries to leak.

• Danger of explosion if battery is incorrectly replaced.

BATTERY REPLACEMENT:

1. Remove the holder from the main body.

2. Twist the top half of the sensor in a counter-clockwise rotation.

3. Remove the spent battery and place 1x CR2-3V battery into the

battery compartment, correctly observing the polarity indications (+/-).

4. Replace the top half of the sensor by rotating it clockwise.

LIMITED WARRANTY:

This NOMA product carries a one (1) year repair warranty against

defects in workmanship and materials. At its discretion, NOMA Canada

agrees to have any defective part(s) repaired or replaced free of

charge within the stated warranty period, when returned with proof of

purchase. This product is not guaranteed against wear or breakage due

to misuse and/or abuse.

BATTERY REPLACEMENT & WARRANTY

FCC PART 15 WARNINGS

This device complies with Part 15 of the FCC rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation. Please note that changes or modiﬁcations of this

product is not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment. This Class B digital apparatus

complies with CAN ICES-005(B).

WARNING: Changes or modiﬁcations to this unit not expressly approved by the

party responsible for compliance could void the user’s authority to operate the

equipment. NOTE: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment o and on, the user is encouraged to

try to correct the interference by one or more of the following measures: Reorient

or relocate the receiving antenna. Increase the separation between the equipment

and receiver. Connect the equipment into an outlet on a circuit dierent from that

to which the receiver is connected. Consult the dealer or an experienced radio/TV

technician for help.

FCC Responsible party:

Globe Electric

2264 East 6th Street

San Bernardino, CA 92410

www.globe-electric.com

FCC WARNING INFO

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined

by turning the equipment o and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit dierent from that to which

the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation. Changes or modiﬁcations not expressly approved

by the party responsible for compliance could void the user’s authority to operate

the equipment.

IC STATEMENT

This device contains licence-exempt transmitter(s)/receiver(s) that comply with

Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause

undesired operation of the device

This Class B digital apparatus complies with CAN ICES-003 (B)/NMB-003 (B).

This equipment should be installed and operated with minimum distance 20 cm

between the radiator and your body.

GUIDE D’UTILISATION

LISEZ ET CONSERVEZ CES INSTRUCTIONS

DÉTECTEUR DE FUITE D’EAU

INTELLIGENT À CONNEXION WIFI

046-3370-2

TABLE DES MATIÈRES

CONTENU DE LA BOÎTE

INSTALLATION

AVERTISSEMENTS

REMPLACEMENT DE LA PILE

GARANTIE

CONTENU DE LA BOÎTE

CAPTEUR D’EAU INTELLIGENT

ACCESSOIRES D’INSTALLATION

SUPPORT ET SONDE

1 X PILE

01.

02.

03.

04.

CR2-3V

01 02 03 04

Capteur

Partie principale

support Voyant à DEL

•

INSTALLATION

Retirez le support de la partie principale. Tournez la partie supérieure du

détecteur dans le sens antihoraire. Une fois le détecteur ouvert, retirez la

petite languette de plastique de la borne de la pile. La pile alimentera le

détecteur, qui passera en mode couplage.

Si ce n’est pas le cas, maintenez le bouton d’alimentation/de

réinitialisation enfoncé pendant 5 secondes, jusqu’à ce qu’il clignote

lentement. Relâchez le bouton, et le détecteur se mettra en mode

couplage.

Aﬁn de coupler l’appareil, veuillez activer et autoriser les services de

localisation et Bluetooth sur votre appareil mobile. Dans l’application

NOMA iQ, sélectionnez le symbole «+» dans le coin supérieur droit.

Sélectionnez l’appareil et suivez les instructions de l’application.

Une fois que le corps principal a été placé à l’endroit prévu, placez la

sonde à l’endroit où une fuite potentielle peut se produire.

Remarque : Une fois que votre capteur d’eau a été connecté à

l’application NOMA iQ, assurez-vous de vériﬁer que le capteur

fonctionne en plaçant la sonde dans l’eau. Le capteur doit s’allumer et

émettre un son lorsqu’il détecte de l’eau.et vous devriez recevoir une

notiﬁcation sur votre téléphone portable indiquant qu’une fuite a été

détectée.

Assurez-vous que l’endroit choisi est propre.

Pendant l’installation, orientez les contacts métalliques du capteur vers

le bas.

Retirer le support de la partie principale. Choisissez votre emplacement

et montez le support à l’aide de la vis et de l’ancrage mural inclus, ou à

l’aide du support adhésif. Insérer la partie principale dans le support et

brancher le capteur

INSTRUCTIONS D’INSTALLATION

•

DÉTECTION DE FUITE

Lorsque la sonde détecte de l’eau, le capteur émet un bip pendant un intervalle de 2

minutes et vous recevez une notiﬁcation sur l’application NOMA iQ. Si la fuite n’est pas

nettoyée dans ce laps de temps, le capteur passera en mode veille pendant environ

2 heures aﬁn d’économiser la batterie. Ce cycle se poursuivra jusqu’à ce que la fuite

soit nettoyée. Si l’appareil est installé en dehors de la portée audible, assurez-vous

de connecter votre capteur à l’application NOMA iQ pour recevoir des notiﬁcations/

alertes. Veillez également à activer les notiﬁcations sur votre téléphone cellulaire.

Note : ne pas laisser la sonde immergée ou en état de fuite pendant plus de 12 heures.

La page est en cours de chargement...

NOMA iQ Battery-Operated Smart Wi-Fi Flood & Water Leak Sensor Le manuel du propriétaire

Marque: NOMA iQ

Modèle: Battery-Operated Smart Wi-Fi Flood & Water Leak Sensor

Taper: Le manuel du propriétaire

Télécharger le PDF

rapport

dans d''autres langues

English: NOMA iQ Battery-Operated Smart Wi-Fi Flood & Water Leak Sensor Owner's manual

Documents connexes

NOMA iQ Battery-Operated Smart Wi-Fi Home Safety Kit Le manuel du propriétaire

NOMA iQ Battery-Operated Smart Wi-Fi Flood & Water Leak Sensor Le manuel du propriétaire

NOMA iQ Battery-Operated Smart Wi-Fi Flood & Water Leak Sensor Le manuel du propriétaire

dans d''autres langues

Documents connexes

Autres documents