©Copyright LOTRONIC 2018
www.bst-dj.com
Page 9
D S P CO N T ROL OF F UL L RA NG E
FI R S T- S e r i e s
Ÿ WALL - is used when the loudspeaker is mounted to the wall using the mounting bracket. This setting compensates
for the amount of low frequency boost created by placing the loudspeaker close to the wall. If used on a column, it is
recommended to use the SUSPENDmode.
Ÿ SUSPEND - is used when the loudspeaker is suspended in a 3-point suspension by eye bolts.
SUB Menu
The Sub menu is used to select a high pass frequency for use with a subwoofer or a matched subwoofer. Available
options for this selection are: OFF, 80Hz, 100Hz, 120Hz, 150Hz, 15"/18". The high passes are 24dB / octave
Linkwitz/Riley crossovers. The 80 Hz, 100 Hz, 120 Hz, and 150 Hz choices are generic high pass settings for use with
other subwoofers. The 15 Sub/18 Sub settings are specifically optimized for subwoofers by including delay for best
summation. The default is OFF.
TREBLE Menu
The Treble menu is used to adjust the high frequency performance of the loudspeaker for different applications or
personal preference. The parameter controls a high shelving filter that is centered on 6 kHz. The range is-12 dB to+ 6
dB. The default is zero (0).
MID Menu
The Mid menu is used to adjust the midrange frequency performance of the loudspeaker for different applications or
personal preference. The parameter controls a parametric EQ that is centered on 1.2 kHz. The range is -12dB to
+6dB. The default is zero (0).
BASS Menu
The Bass menu is used to adjust the low frequency performance of the loudspeaker for different applications or
personal preference. The parameter controls a parametric EQ filter that is centered on 80 Hz. The default is zero (0).
DELAY Menu
The DELAY menu is used to adjust the delay time, The range is 0-30ms.
BTH VOL Menu
The bluetooth menu on the DSP is used to match and connect with the bluetooth on the mobile devices. Inter the menu
and adjust the Volume to the range of 0-16,at the same time make the bluetooth in the searching condition., and the
bluetooth symbol flashing on the LCD. Then open the bluetooth on the moble device to match with the bluetooth in the
loudspeaker. The bluetooth symbol stop flashing when the bluetooth match success. At this time you can play music
on the speaker via mobile devices, and the range of 0-16 is to control the loudspeaker bluetooth volume. the
loudspeaker bluetooth closed when adjust to 0.
LCD DIM Menu
The LCD Dim menu is used to dim the display when the display is idle for twenty second. Available options for this
selection are: ON or OFF. The default is ON.
BRIGHT Menu
The Bright menu is used to determine the brightness of the LCD. The range is 1 to 10. The default is 5.
CONTRAST Menu
The Contrast menu is used to determine the contrast on the LCD. The range is 1 to 10. The default is 5.
RESET Menu
The Reset menu is used to reset the loudspeaker to original factory settings. Available options for this selection are:
NO or YES. The default selection is NO. To reset the system to original factory settings, do the following:
1. From the DSP menu, select RESET.
The reset Confirm Reset message appears
2. Select YES.
The loudspeaker restarts and resets the system to the original factor settings.
INFO Menu
The Information menu is used to display the Brand, product name and firmware version.