Yokogawa Electric F9092LD ISA100 Wireless Module Manuel utilisateur

Taper
Manuel utilisateur
Model: F9092LD
Doc. No.: WFC019-A06
Date: 29 January 2021
Rev.0:
Yokogawa Electric Corporation
1 / 4
User Manual
Model : F9092LD
Kind of Product : ISA100 Wireless Module
Model: F9092LD
Doc. No.: WFC019-A06
Date: 29 January 2021
Rev.0:
Yokogawa Electric Corporation
2 / 4
Since this module is not sold to general end users directly, there is no user manual of module.
For the details about this module, please refer to the specification sheet of module.
This module should be installed in the host device according to the interface specification
(installation procedure).
The following information must be indicated on the host device of this module;
[for FCC]
Contains Transmitter Module FCC ID: SGJ-WFC019
or
Contains FCC ID: SGJ-WFC019
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
*If it is difficult to describe this statement on the host device due to the size, please describe in the user's manual and
also either describe on the device packaging or on a removable label attached to the device.
[for ISED(IC)]
Contains IC: 8999A-WIC017
Model: F9092LD
Doc. No.: WFC019-A06
Date: 29 January 2021
Rev.0:
Yokogawa Electric Corporation
3 / 4
The following statements must be described on the user manual of the host device of this
module;
[for FCC]
FCC CAUTION
Changes or
modifications not expressly approved by the party responsible for
compliance could void the userʼs authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines. This equipment should be installed and operated keeping the radiator at
least 20 cm or more away from personʼs body.
[for ISED(IC)]
This device contains licence-
exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canadaʼs licence-
exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
Lʼémetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR Innovation, Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. Lʼexploitation est autorisée aux deux conditions
suivantes:
1. Lʼappareil ne doit pas produire de brouillage;
2. Lʼappareil doit accepter tout brouillage radioélectrique subi, me si le brouillage
est susceptible dʼen compromettre le fonctionnement.
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment and meets RSS-102 of the ISED radio frequency (RF)
Exposure rules. This equipment should be installed and operated keeping the radiator
at least 20 cm or more away from personʼs body.
Cet équipement est conforme aux limites dʼexposition aux rayonnements énoncées
pour un environnement non contrôlé et respecte les règles exposition aux fréquences
radioélectriques (RF) CNR-102 de lʼISDE. Cet équipement doit être installé et utilisé
en gardant une distance de 20 cm ou plus entre le radiateur et le corps humain.
Model: F9092LD
Doc. No.: WFC019-A06
Date: 29 January 2021
Rev.0:
Yokogawa Electric Corporation
4 / 4
[List of applicable FCC rules]
This device complies with below part 15 of the FCC Rules.
Part 15 Subpart C
[Additional testing, Part 15 Subpart B disclaimer]
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter
rules) listed on the grant, and the host product manufacturer is responsible for compliance to
any other FCC rules that apply to the host not covered by the modular transmitter grant of
certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular
transmitter installed.
[Information on test modes and additional testing requirements]
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Yokogawa Electric F9092LD ISA100 Wireless Module Manuel utilisateur

Taper
Manuel utilisateur