Silex technology SXNEWAH Manuel utilisateur

SXNEWAH
Marque
Silex technology
Modèle
SXNEWAH
Taper
Manuel utilisateur
User Manual
Since this module is not sold to general end users directly, there is no user manual of
module.
For the details about this module, please refer to the specification sheet of module.
This module should be installed in the host device according to the interface specification
(installation procedure).
FCC Notice
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
List of applicable FCC rules
This device complies with below part 15 of the FCC Rules.
Part 15 Subpart C
Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules)
listed on the grant, and the host product manufacturer is responsible for compliance to any other FCC
rules that apply to the host not covered by the modular transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter
installed.
Summarize the specific operational use conditions
This module designed for mounting inside of the end product by end product manufacturer
professionally.
Therefore, it complies with the antenna and transmission system requirements of §15.203.
RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and
operated keeping the radiator at least 20cm or more away from personʼs body.
Co-Location Rule
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
Label and compliance information
Following information must be indicated on the host device of this module.
Contains Transmitter Module FCC ID：N6C-SXNEWAH
Or
Contains FCC ID：N6C-SXNEWAH
FCC CAUTION
The following statements must be described on the user manual of the host device of this module;
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could
void the userʼs authority to operate the equipment.
Antenna List
Vender Model No. Antenna Type Antenna Gain [dBi]
STAF T16-062-1022 PCB 3.0
ethertronics 9000984-XLPDNB ROD 3.4
PSA (Walsin) RFDPA131000SMRB801 ROD 3.01
Invax AN0915-13D01BSM ROD 2.00
SaemON Technology SME‒G0900DEN ROD 1.26
Taoglas IS.05.B.3010021 thread-mount 2.40
Limited module procedures
This module needs to supply a regulated voltage to VDDFEM from host device.
ISED Notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canadaʼs licence-exempt RSS(s). Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation
of the device.
Lʼémetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
dʼInnovation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. Lʼexploitation est autorisée aux deux conditions suivantes :
1. Lʼappareil ne doit pas produire de brouillage;
2. Lʼappareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
dʼen compromettre le fonctionnement.
Label and compliance information
The following information must be indicated on the host device of this module.
Contains Transmitter Module IC: 4908A-SXNEWAH
Or
Contains IC: 4908A-SXNEWAH
RF exposure considerations
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment
and meets RSS-102 of the ISED radio frequency (RF) Exposure rules. This equipment should be installed
and operated keeping the radiator at least 20cm or more away from personʼs body.
Cet équipement est conforme aux limites dʼexposition aux rayonnements énoncées pour un
environnement non contrôlé et respecte les règles dʼexposition aux fréquences radioélectriques (RF)
CNR-102 de lʼISDE. Cet équipement doit être installé et utilisé en gardant une distance de 20 cm ou
plus entre le radiateur et le corps humain.
Antenna Type
This radio transmitter (4908A-SXNEWAH) has been approved by Innovation, Science and Economic
Development Canada to operate with the antenna types listed below, with the maximum permissible
gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain
indicated for any type listed are strictly prohibited for use with this device.
Antenna Type Gain Impedance
Rod Antenna 3.4dBi 50ohms
PCB Antenna 3.0dBi 50ohms
thread-mount Antenna 2.40dBi 50ohms
Le présent émetteur radio (4908A-SXNEWAH) a été approuvé par Innovation, Sciences et
Développement économique Canada pour fonctionner avec les types d'antenne énumérés ci-dessous
et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est
supérieur au gain maximal indiqué pour tout type figurant sur la liste, sont strictement interdits pour
l'exploitation de l'émetteur.
Type d'antenne Gain Impedance
Antenne à tige 3.4dBi 50ohms
Antenne PCB 3.0dBi 50ohms
Antenne à montage fileté 2.40dBi 50ohms
Limited module procedures
This module needs to supply a regulated voltage to VDDFEM from host device.
Ce module doit fournir une tension régulée à VDDFEM à partir du périphérique hôte.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Silex technology SXNEWAH Manuel utilisateur

SXNEWAH
Marque
Silex technology
Modèle
SXNEWAH
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents