Topcon 333047 Manuel utilisateur

Taper
Manuel utilisateur
Since this module is not sold to general end users directly, there is no user manual of module.
For the details about this module, please refer to the specification sheet of module.
This module should be installed in the host device according to the interface specification
(installation procedure).
This device complies with below part 15 of the FCC Rules.
Part 15 Subpart C
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC
transmitter rules) listed on the grant, and the host product manufacturer is responsible for
compliance to any other FCC rules that apply to the host not covered by the modular
transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular
transmitter installed.
Model No. Antenna Type Antenna Gain
1029-C17586 Sleeve 2.14 dBi
1. REGULATION
The following information must be indicated on the host device of this module;
[for FCC]
Contains FCC ID: H5P-333047
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
*If it is difficult to describe this statement on the host device due to the size, please
describe in the user's manual and also either describe on the device packaging or on a
removable label attached to the device.
[for ISED(IC)]
Contains IC: 6050A-333047
The following statements must be described on the user manual of the host device of this
module;
[for FCC]
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance
could void the userʼs authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines. This
equipment should be installed and operated keeping the radiator at least 20cm or more
away from personʼs body.
[for ISED]
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canadaʼs licence-exempt RSS(s).
Operation is subject to the following two conditions:
1.This device may not cause interference.
2.This device must accept any interference, including interference that may cause
undesired operation of the device.
Lʼémetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR dʼInnovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. Lʼexploitation est autorisée aux deux conditions
suivantes :
1.Lʼappareil ne doit pas produire de brouillage;
2.Lʼappareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible dʼen compromettre le fonctionnement.
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment and meets RSS-102 of the ISED radio frequency (RF)
Exposure rules. This equipment should be installed and operated keeping the radiator at
least 20cm or more away from personʼs body.
Cet équipement est conforme aux limites dʼexposition aux rayonnements énoncées pour
un environnement non contrôlé et respecte les règles dʼexposition aux fréquences
radioélectriques (RF) CNR-102 de lʼISDE. Cet équipement doit être installé et utilisé en
gardant une distance de 20 cm ou plus entre le radiateur et le corps humain.
This radio transmitter (6050A-333047) has been approved by Innovation, Science and
Economic Development Canada to operate with the antenna types listed below, with the
maximum permissible gain indicated. Antenna types not included in this list that have a
gain greater than the maximum gain indicated for any type listed are strictly prohibited
for use with this device.
Antenna type Gain Impedance
Sleeve 2.14 dBi 50 Ω
Le present émetteur radio (6050A-333047) a été approuvé par Innovation, Sciences et
Développement économique Canada pour fonctionner avec les types dʼantenne énumérés
ci-dessous et ayant un gain admissible maximal. Les types dʼantenne non inclus dans
cette liste, et dont le gain est supérieur au gain maximal indiqué pour tout type figurant
sur la liste, sont strictement interdits pour lʼexploitation de lʼémetteur.
Type dʼ antenne Gain Iʼimpédance
Sleeve 2.14 dBi 50 Ω
  • Page 1 1
  • Page 2 2
  • Page 3 3

Topcon 333047 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues