1
05/03 P/N 211979C
Customer Service
N53 W24700 South Corporate Circle
Sussex, WI 53089
U.S.A.
A Huffy Company
WRITE IN YOUR MODEL NUMBER:
________________
REQUIRED TOOLS AND
MATERIALS:
• Step Ladder 8 ft. (2.4 m)
• Adjustable Wrench
• Wrenches: 7/16”, 1/2”, 9/16”, 3/4”
Backboard and Rim Owners Manual
Toll-Free Customer Service Number for U.S: 1-800-558-5234 Canada Only: 1-800-284-8339
For Australia: 1-800-632-792 Internet Address: http://www.huffysports.com
In U.S. and Canada only: Have questions...don’t go back to the store!
We appreciate your purchasing one of our many fine products. We are sure that you will be very satisfied with your selection. Although
great care and effort have been taken, occasionally problems may occur. To ensure prompt and correct handling of any problems, or to
answer any questions, please contact our Toll-Free Customer Service Number listed below. Service will be quicker if you have your
Model Number (found on carton) and assembly instructions ready when calling. PLEASE WRITE YOUR MODEL NUMBER IN
THE SPACE PROVIDED ABOVE.
SAFETY INSTRUCTIONS
Most injuries are caused by misuse and/or not following instructions.
Use caution when using this system.
• If using a ladder during assembly, use extreme caution.
• Two (2) people are recommended for this operation.
• Check base regularly for leakage. Slow leaks could cause system to tip over
unexpectedly.
• Seat the pole sections properly (if applicable). Failure to do so could allow the pole
sections to separate during play and/or transport of the system.
• Climate, corrosion or misuse could result in system failure.
• Minimum operational height is 6' 6" (1.98 m) to the bottom of backboard.
• This equipment is intended for home recreational use only and NOT excessive
competitive play.
• Read and understand the warning label affixed to pole. Label is shown on page 1.
• The life of your basketball pole depends on many conditions. The climate,
placement of the pole, the location of the pole, exposure to corrosives such as
pesticides, herbicides or salts are all important.
• If technical assistance is required, contact Huffy Sports.
• Adult supervision is recommended when adjusting height.
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY, PROPERTY DAMAGE AND WILL VOID WARRANTY.
Owner must ensure that all players know and follow these rules for safe
operation of the system.
To ensure safety, do not attempt to assemble this system without following the
instructions carefully. Proper and complete assembly, use and supervision is
essential for proper operation and to reduce the risk of accident or injury. A high
probability of serious injury exists if this system is not installed, maintained, and
operated properly. Check entire box and inside all packing material for parts
and/or additional instructional material. Before beginning assembly, read the
instructions and identify parts using the hardware identifier and parts list in this
document.
For more information on assembly, placement, proper use and maintenance, visit
The American Basketball Council website at http://www.smarthoops.com.
WARNING
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT
IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.
Owner must ensure that all players know and
follow these rules for safe operation of the unit.
In the U.S.: 1-800-558-5234 and Canada Only: 1-800-284-8339
206118 5/97
See instruction manual for proper installation and
maintenance.
Use caution when performing dunk type activities on this unit.
Do not hang from any part of unit, including backboard,
support braces, rim or net.
Check unit before each use for loose hardware, excessive
wear and signs of corrosion and repair before using.
During play, use extreme caution to keep player's face away
from the backboard, rim or net. Serious injury could occur if
teeth/face come in contact with backboard, rim or net.
During play, do not wear jewelry (rings, watches, necklaces,
etc.) Objects may entangle in net.
·
·
·
·
·
·
© COPYRIGHT 2002 by HUFFY SPORTS
P/N 211979C 05/03
2
BEFORE YOU START!
To ensure optimal playability of backboard system, a close tolerance fit between the elevator
components and hardware is required. Test fit large bolts into large holes of elevator tubes,
backboard brackets and triangle plates. Carefully rock them in a circular motion to ream out
any excess paint from holes if necessary.
AVANT DE COMMENCER !
Pour garantir l'utilisation optimale du panneau, les composants du système élévateur et la visserie doivent être bien
ajustés (serrés). À titre d'essai, insérez les gros boulons dans les gros trous des tubes du système élévateur, des supports
du panneau et des plaques triangulaires. Basculez-les avec précaution en imprimant un mouvement circulaire pour
éliminer l'excédent de peinture, si nécessaire.
¡ANTES DE COMENZAR!
Para asegurar el óptimo rendimiento del sistema del respaldo en el juego, se requiere un ajuste de tolerancia estrecha
entre los componentes del elevador y el herraje. Pruebe el ajuste de los pernos grandes en los orificios grandes de los
tubos elevadores, soportes del respaldo y placas triangulares. Cuidadosamente muévalos en círculos para eliminar
cualquier exceso de pintura, si es necesario.
VORBEREITENDE MASSNAHMEN
Um sicherzustellen, dass das Korbwandsystem optimal für den Spielbetrieb geeignet ist, müssen die Komponenten der
Verlängerungsvorrichtung und die verschiedenen Befestigungsteile fest miteinander verschraubt werden. Große Schrauben
zur Probe in die großen Löcher der Verlängerungsrohre, Korbwandklammern und Dreiecksplatte stecken und diese
vorsichtig in einer Kreisbewegung hin- und herbewegen, um eventuelle Farbrückstände aus den Bohrungen zu entfernen.
05/03 P/N 211979C
3
P/N 211979C 05/03
Item
Qty. Part No. Description
1 4 202341 “L” Bracket
2 2 200837 Spacer, Plastic
3 6 201107 Bolt, Hex Head, 1/4-20 x 1/2 Long
4 6 203326 Washer, Lock, 1/4
5 6 203228 Nut, 1/4-20
6 8 203100 Hex Flange Nut 5/16-18
7 4 203104 Bolt, Hex Flange, 5/16-18 x 2 Long
8 2 900964 Bracket, Backboard Support
9 2 206360 Bolt, Hex Head, 3/8-16 x 2.625 Long
10 2 200874 Spacer, Steel .402 I.D. x .50 O.D. x 1.5 Long
11 2 201124 Nut, 3/8-16
12 1 Rim
13 12 201219 Clip, Net Holder, Smart Clips
14 1 Net
15 4 205528 Bolt, Hex Flange, 5/16-18 x 1 Long
16 8 203309 Washer, Flat
Item #13 (12*)
HARDWARE IDENTIFIER
PARTS LIST - See Hardware Identifier
* You May Have Extra Parts With This Model.
Item #3 (6)
Item #5 (6)
Item #6 (8)
Item #11 (2)
Item #15 (4)
Item #16 (8)
Item #4 (6)
Item #10 (2)
Item #7 (4)
Item #9 (2)
P/N 211979C 05/03
4
05/03 P/N 211979C
ASSEMBLY INSTRUCTIONS
IMPORTANT! WRITE MODEL NUMBER FROM BOX ONTO PAGE 1 OF THIS OWNERS MANUAL
WARNING: USE OF THIS PRODUCT WITHOUT PROPER INSTALLATION OF SMART CLIPS, OR WHEN ALL SMART CLIPS ARE NOT
PRESENT COULD RESULT IN BODILY HARM. BE SURE TO FOLLOW DIRECTIONS CAREFULLY.
1. Attach Backboard and rim using one of the options as shown.
2. Install net clips as shown (See Illustration).
3. Install net as shown (See Illustration).
4. Place warning label (1) in location clearly visible within playing area.
WARNING: TWO PEOPLE ARE NECESSARY TO MOUNT THE BACKBOARD ASSEMBLY TO SUPPORT STRUCTURE. ONE PERSON
SHOULD NOT ATTEMPT TO DO THIS ALONE.
WARNING: MOUNTING THE BACKBOARD ASSEMBLY TO THE SUPPORT STRUCTURE IS PERFORMED AT AN ELEVATED HEIGHT. USE
PROPER PRECAUTION.
WARNING: IT IS RECOMMENDED TO MOUNT BACKBOARD TO A SOLID (STEEL) SUPPORT.
10 ft.
(3.05M)
REGULATION RIM HEIGHT
IS 10 FEET (3.05M).
• La hauteur réglementaire du cerceau et à 3,05 m (10 pieds).
• La altura oficial del borde (NBA) es de 3.05 m (10 pies).
• Die offizielle Korbhöhe in der National Basketball Association
der U.S.A. (NBA) ist 3,05 m (10 Fuß).
05/03 P/N 211979C
5
P/N 211979C 05/03
IMPORTANT!
For spring loaded rim assembly, refer to instructions included with rim hardware.
IMPORTANT! WRITE DOWN MODEL NUMBER FROM BOX ON PAGE 1 OF THIS OWNERS MANUAL
WARNING: IF YOUR SYSTEM IS EQUIPPED WITH AN ACRYLIC
BACKBOARD, EXAMINE BACKBOARD FOR ANY DAMAGE THAT MAY
HAVE OCCURRED DURING SHIPMENT. CRACKS IN THE BACKBOARD
COULD RESULT IN SUDDEN BREAKAGE. IF BACKBOARD IS DAMAGED
IN ANY WAY PRIOR TO OR AFTER ASSEMBLY, CALL TOLL-FREE
NUMBER FOR FREE REPLACEMENT:
U.S. 1-800-558-5234; CANADA: 1-800-284-8339; http://www.huffysports.com
EXTENSION ARM MOUNT
1
7
6
15
2
6
16
5
4
1
3
Peel protective film from
surface of acrylic
backboard prior to use.
NOTE:
NOTE:
We recommend mounting backboard to a solid
material (steel) behind rim area.
IMPORTANT!
For spring loaded rim
assembly, refer to
instructions included with
rim hardware.
P/N 211979C 05/03
6
05/03 P/N 211979C
Model 8406 Universal Mounting Bracket is available for purchase
by calling this number: 1-800-558-5234
POLE, ROOF, OR WALL MOUNT
15
15
6
6
WALL MOUNT
3
3
4
5
5
4
POLE MOUNT
IMPORTANT!
For spring loaded rim
assembly, refer to
instructions included with
rim hardware.
Model 8406 Universal
Mounting Bracket
05/03 P/N 211979C
7
P/N 211979C 05/03
ELEVATOR MOUNT
1
6
1
3
5
ROOF MOUNT
Top View
3
16
5
4
Model 8406 Universal Mounting Bracket
is available for purchase by calling this
number: 1-800-558-5234
4
4
10
9
9
11
11
8
10
3
5
15
IMPORTANT!
For spring loaded rim
assembly, refer to
instructions included with
rim hardware.
P/N 211979C 05/03
8
05/03 P/N 211979C
8
8
6
6
15
Peel protective film from
surface of acrylic
backboard prior to use.
NOTE:
ELEVATOR MOUNT (continued)
Use existing elevator
components.
NOTE:
Use existing elevator
components.
NOTE:
IMPORTANT!
For spring loaded rim
assembly, refer to
instructions included with
rim hardware.
05/03 P/N 211540C
9
P/N 211979C
BRONZE RATCHET ELEVATOR MOUNT
IMPORTANT!
Test fit bolts into holes of backboard brackets and
carefully rock them in a circular motion to ream
paint from holes if necessary.
8
10
10
9
9
11
8
8
Use existing elevator
components.
NOTE:
P/N 211540C 05/03
10
P/N 211979C
Use existing elevator
components.
NOTE:
Use existing elevator
components.
NOTE:
BRONZE RATCHET ELEVATOR MOUNT (continued)
05/03 P/N 211979C
11
P/N 211979C 05/03
STAMPED RATCHET ELEVATOR MOUNT
10
9
9
11
11
8
10
IMPORTANT!
Test fit bolts into holes of backboard brackets and
carefully rock them in a circular motion to ream
paint from holes if necessary.
Use existing elevator
components.
NOTE:
P/N 211979C 05/03
12
05/03 P/N 211979C
STAMPED RATCHET ELEVATOR MOUNT (continued)
8
IMPORTANT!
It is necessary for all parts to
be installed properly for this
mechanism to work safely
and properly.
Use existing elevator
components.
NOTE:
Use existing elevator
components.
NOTE:
05/03 P/N 211979C
13
P/N 211979C 05/03
STAMPED RATCHET ELEVATOR MOUNT (continued)
Use existing elevator
components.
NOTE:
IMPORTANT!
For spring loaded rim
assembly, refer to
instructions included with
rim hardware.
P/N 211979C 05/03
14
05/03 P/N 211979C
WARNING:
Use of this product without proper installation of net
clips, or when all net clips are not present could result in bodily harm. Be
sure to follow directions carefully.
Install net clips.
CLIP “ARM”
CLIP “BODY”
Insert one “arm” of clip into ram as shown. Twist “body” of clip slightly so that second
“arm” slides over the top of the first “arm” as shown.
Push in direction indicated by arrows.
Push second “arm” back and into ram as shown.
Twist “body” of clip slightly again to spread “arms” of clip.
Clip “arms” must be flat and touching edge to edge as shown, not overlapping.
AA
BB
CC
12
13
2.
05/03 P/N 211979C
15
P/N 211979C 05/03
Insert net into bottom of clip as shown.
SIDE VIEW
Twist net until it snaps into position.
Net must be centered through clip.
NET
NETCLIP
SIDE VIEW
NET
NETCLIP
NET INSTALLATION
12
14
13
3.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
Huffy basketball Manuel utilisateur
- Taper
- Manuel utilisateur
- Ce manuel convient également à
dans d''autres langues
- English: Huffy basketball User manual