Ring 5B21S8-BEN0 Manuel utilisateur

5B21S8-BEN0
Ring
Marque
Ring
Modèle
5B21S8-BEN0
Taper
Manuel utilisateur
Floodlight Battery
Smart Lighting
02_Battery_Floodlight_MANUAL.indd 1 1/8/19 2:40 PM
1. Set up your Floodlight.
Download from
Windows Store
Download from
Windows Store
Download the Ring app.
The app walks you through setting up and managing
your Ring Floodlight Battery.
Search for “Ring” in one of these
app stores, or visit: ring.com/app
Set up your Ring Bridge.
The Bridge connects your Ring
Smart Lights to the Ring app
and other compatible Ring
devices.
To set up your Bridge, follow
the instructions in the Ring app
or the Bridge user manual.
32
02_Battery_Floodlight_MANUAL.indd 3 1/8/19 2:40 PM
Remove the back cover.
Twist your Floodlight counter-clockwise to unlock
and separate it from the back cover.
Remove the battery lid.
Press the side buttons on the battery lid to remove
it and open the battery compartment.
54
02_Battery_Floodlight_MANUAL.indd 5 1/8/19 2:40 PM
Smart Lights
Alarm
Doorbells
Security Cams
Chimes
Set up your Floodlight Battery
in the Ring app.
In the app, tap Set Up a Device.
When prompted, select Smart
Lights and follow the in-app
instructions.
After setup, replace the back cover
(be sure to line up the arrows).
Insert four D-Cell batteries,
then slide the battery cover
back onto Floodlight Battery.
Insert the
batteries.
Insert four D Cell
batteries (not included),
matching the flat ends
with the springs.
Then place the lid onto
the compartment and
push down to snap it
into place.
6
02_Battery_Floodlight_MANUAL.indd 6-7 1/8/19 2:40 PM
2. Install your Floodlight.
Remove the
mounting plate.
Press the tab on the
side and slide the
mounting plate o of
the back cover.
Mark pilot holes.
If installing on a
masonry surface, use
the mounting plate as a
template to mark pilot
holes, making sure the
“UP” arrow is pointing
upwards.
Then drill the holes and
insert the anchors.
98
02_Battery_Floodlight_MANUAL.indd 9 1/8/19 2:40 PM
Mount your
Floodlight.
Align your Floodlight
with the mounting plate
and slide it to the left to
lock it in.
Drive the screws.
Hold the mounting
plate firmly against the
surface and drive the
three mounting screws.
The motion sensor is
adjustable. Try various
angles to find the best
setting for your home.
1110
02_Battery_Floodlight_MANUAL.indd 10-11 1/8/19 2:40 PM
For additional help, visit: ring.com/help
Or give us a call…
US 1 800 656 1918
Canada 1 855 300 7289
Worldwide +1 310 929 7085
To review your warranty coverage, please visit www.ring.com/warranty.
Patents: www.ring.com/patents
© 2019 Ring LLC or its aliates.
Ring, Alexa, Always Home, and all related logos are trademarks of Amazon.com, Inc. or its aliates.
Last updated: 01/08/19
For a list of all our customer support numbers, visit: ring.com/callus
02_Battery_Floodlight_MANUAL.indd 12 1/8/19 2:40 PM
Models: Ring Motion Sensor (5SM1S8), Ring Spotlight (5B11S8), Ring Steplight (5LD1S8),
Ring Pathlight (5LP1Y8), Ring Floodlight Battery (5B21S8), Ring Floodlight Wired
(5W21S8), Ring Transformer (5AT1S9)
Canada
CAN ICES-3 (B)/NMB-3(B)
Innovation, Science and Economic Development Canada (ISED) Compliance. This device
contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s license-exempt RSS(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of the device.
Conformité Innovation Sciences et Développement Économique Canada (ISDE)
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
Information Regarding Exposure to Radio Frequency Energy: This equipment complies
with IC RSS-102 RF exposure limits set forth for an uncontrolled environment.
Informations concernant l’exposition aux radiofréquences: Cet équipement est conforme
aux limites d’exposition aux rayonnements IC établies pour un environnement non
contrôlé.
MPE Reminding
This equipment should be installed and operated with minimum distance 20 cm between
the radiator and your body.
Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre
la source de rayonnement et votre corps.
United States
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. Information on
this device is on file with the FCC and can be found by inputting the device’s FCC ID into
the FCC ID Search form available at https://www.fcc.gov/oet/ea/fccid.
The output power of the radio technology used in the Products is below the radio
frequency exposure limits set by the FCC. Nevertheless, it is advised to use the Products
in such a manner that minimizes the potential for human contact during normal
operation. This device should be installed and operated with at least 20 cm between the
radiator and your body.
General
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
1523 26th St.
Santa Monica, CA 90404
Ring_Smart_Lights_legal.indd 1 3/8/19 12:09 PM
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
Electrical ratings:
Motion Sensor: 3 x AAA-cell batteries
Spotlight: 4 x D-cell batteries
Steplight: 3 x C-cell batteries
Pathlight: 4 x D-cell batteries
Floodlight Battery: 4 x D-cell batteries
Floodlight Wired: 110-240 VAC, 50-60 Hz
Transformer: 120 VAC, 60 Hz, 200 W maximum load
This device may require batteries for use. Only use the specified battery types. Never
mix old and new batteries. Install batteries with correct polarity. Do not mix Alkaline,
Standard Carbon Zinc, Rechargeable Nickel Cadmium or Nickel Metal Hydride batteries.
Keep all of the batteries out of the reach of children. Do not open, disassemble,
puncture, cut, bend, shred or heat the batteries. Remove all batteries if they are
worn out or before storing your device for an extended period of time. Dispose of
all batteries in accordance with applicable laws and regulations and do not dispose
of batteries by throwing them into a fire. If any batteries begin to leak, take steps
to prevent the fluid from coming into direct contact with skin or clothes as the fluid
could be corrosive and may be toxic. Remove the batteries and clean the battery
compartment in accordance with the battery manufacturer’s recommendations.
Operating conditions:
Floodlight Battery: -4°F to 122°F (-20°C to 50°C)
Motion Sensor: -4°F to 122°F (-20°C to 50°C)
Pathlight: -4°F to 122°F (-20°C to 50°C)
Spotlight: -4°F to 122°F (-20°C to 50°C)
Steplight: -4°F to 122°F (-20°C to 50°C)
Transformer: -4°F to 122°F (-20°C to 50°C)
Small parts may pose choking hazards. Keep device and box contents out of reach of
children.
To review your warranty coverage, please visit www.ring.com/warranty
Patents: www.ring.com/patents
© 2019 Amazon.com, Inc. or its affiliates.
RING, ALWAYS HOME, ALEXA, and all related logos are trademarks of Amazon.com, Inc.
or its affiliates.
Version 1.1
Ring_Smart_Lights_legal.indd 2 3/8/19 12:09 PM
Floodlight Wired: -4°F to 118°F (-20°C to 48°C)
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

Ring 5B21S8-BEN0 Manuel utilisateur

5B21S8-BEN0
Ring
Marque
Ring
Modèle
5B21S8-BEN0
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents