Malone MPG537 Manuel utilisateur

Taper
Manuel utilisateur
MALONE
R
MALONE
R
DownLoaderDownLoaderTM
J-STYLE FOLDING KAYAK CARRIER
12’ Safety LinesJawz Universal Adapters Mounting BoltsKayak Carriers Load Straps T-Knobs
60mm
70mm
Installation & Loading Instructions - Please Read Before Beginning
Veuillez lire les instructions avant d’entreprendre l’installation et le chargement
1
3
2
. Insert Mounting Bolt through one hole of a Jawz adapter.
Insert washer and loosely apply a T-knob. See image 2.
. Faites passer le boulon de fixation dans l’un des trous
d’un adaptateur Jawz puis vissez légèrement un bouton
en ‘‘T’ à la base du boulon. (Figure 2)
. Prior to installation, insert a bolt into the mounting holes in
the bottom of the carriers. Push upward to open the two
mounting hole covers located in the Base pads.
. Insert a Mounting Bolt into one mounting hole from the top
side. Rotate and close the mounting hole cover.
See image 1.
. Insérez un boulon de fixation dans l’un des trous hexagonaux
situés sur le côté supérieur du support.
(Figure 1)
. Place the carrier onto the front cross bar with the boarding
ramp facing out. Swing the Jawz under the cross bar as
shown. See image 3.
. Placez le support sur la barre transversale avant, la rampe
de chargement vers l’extérieur. Faites passer l’adaptateur
Jawz sous la barre transversale, tel qu’indiqué. (Figure 3)
1
Mounting Bolt Washers
Base Pad
Covers
IMPORTANT WARNING: All vehicular transports are potentially hazardous. Any person(s) using Malone products are personally responsible for
following the given directions for use and/or installation and accepts full responsibility for any and all damages or injury of any kind including death,
which may result from their use and/or installation.
It is critical that all Malone racks and accessories be properly and securely attached to your vehicle. Improper attachment could result in a serious
accident, and could cause serious bodily injury or death to you or to others. You are responsible for securing the racks and accessories to your car,
checking the attachment’s prior to use, and periodically inspecting the products for adjustment, wear, and damage.
You must read and understand all of the instructions and cautions supplied with your Malone products(s) prior to installation or use. If you do not
understand all of the instructions and cautions, or, if you have no mechanical experience and are not thoroughly familiar with the installation
procedures, you should have the product installed by a professional installer.
MISE EN GARDE IMPORTANTE: Tout transport d’un chargement sur le toit d’un véhicule est potentiellement dangereux. Une personne qui
utilise les produits Malone doit suivre sans faute les instructions d’installation et d’utilisation fournies et assume l’entière responsabilité pour tout
dommage ou toute blessure, y compris un décès, pouvant résulter d’une telle installation ou utilisation.
Il est essentiel de xer correctement et solidement les supports et les accessoires à votre véhicule. Une mauvaise installation ou attache pourrait
provoquer un accident, entraîner des blessures corporelles graves à vous et aux autres et même causer la mort. Vous avez la responsabilité de
xer solidement les supports et les accessoires à votre véhicule, de vérier l’installation avant l’utilisation et d’inspecter périodiquement le produit
pour déceler tout signe d’usure ou de dommage ou tout problème d’ajustement.
Vous devez lire et comprendre les instructions et les mises en garde fournies avec les produits Malone avant l’installation et l’utilisation. Si vous
ne comprenez pas les instructions et les mises en garde ou si vous ne possédez pas d’expérience en mécanique et ne connaissez pas à fond les
procédures à suivre d’installation, vous devriez faire monter et poser le produit par un installateur professionnel.
MPG537 Sliding Cargo Box
for your
Malone MegaSport Trailer
Assembly & Installation Instructions
TM
MPG537
Important Note
Product Warranty & Registration Form
All information is condential and used exclusively by MALONE only.
MALONE
R
MALONE AUTO RACKS 81 County Rd. Ste 1, Westbrook, ME 04092
P: 207.774.9100 F: 207.615.0551
E: support@maloneautoracks.com W: www.maloneautoracks.com
Dear Customer,
Thank you for your purchase of a Malone Product.
In order to be eligible for the Malone Warranty program, we ask that you contact us online at the link provided
below: With-in 30 days of purchase. You can also mail this letter back to the address at the bottom.
• Online: https://maloneautoracks.com/product-registration.php
We will require the information below.
Here is the information collected:
First Name:
Last Name:
Address:
Address2:
City:
State:
Zip:
Country:
Email:
Phone:
Product Description/Name:
Product MPG#
Date Purchased:
Store Where Purchased:
Purchase Price:
Thank you for choosing Malone!
MALONE
R
Cargo Box (1)
Handle Cleats (2)
Support Rollers (2)
Channel Guides (2) w/
Hardware Kit
Retaining Handle (2) Wheels (2)
Drain Plug (1)
Lid Retainers (2)
Box Assembly
1). Handles: Install the retaining handles to ends of the box. Large washer and nut go on the inside.
Repeat for second handle on other side.
2). Drain Plug: Insert the drain plug and secure with the self-tapping screws.
A B C D E
A B
Support Rollers: Press in one side of the support rollers end tab and insert into the center rails of the
trailer frame as pictured. NOTE: with the edge roller being on the passengers side.
3). Wheels: Insert bolt through wheel. Add 2 small washers as a spacer between the wheel and the cargo
box. We use another large washer on the inside of the box and secure with nylon lock nut. Repeat for
second wheel. Do not over tighten, wheel must be able to roll. Extra washers provided for more spacing if
needed.
Handle Cleats: First measure the distance between the two center cross members and mark the center
point (at 6”). Next line up the center of the handle cleat with center mark you just made. Lining up the bottom
of the cleat with bottom edge of the top frame rail, mark the two mounting holes for the cleat.
4). Lid: Complete the cargo-box by adding the lid and securing with the carabiners. Note: Lid is not 100%
water proof. Valuable items need to be protected.
1). Remove the bolts and nuts (2 on each side of the
trailer) from the top edge of the frame rail and cross
member as shown. This will prevent any marking of
the cargo box as it slides back and forth.
3). Place channel guides over the oval holes and
secure from the bottom upwards with bolt and washer
and the nut on the top (inside the channel). Repeat for
all 4 bolts. Leaving them loose for the nal next step.
2). Using a 5/32 drill bit, pre-drill the holes for the cleat. Secure with the 2 self tapping screws.
Repeat process for second cleat on other side.
Rail Guide Assembly
2). Next we’ll install the channel guides utilizing the
larger oval holes next to the bolts we just removed.
4). Next, insert the longer bolt into the hole closest
to the passengers side of the trailer on the channel
guides. This will act as a ‘break’ or stop when pulling
out the cargo box. Secure with nylon nut on the
underside.
With the guide rails loosely attached insert/slide the cargo-box into the channels. Next, push the rail guides
inwards towards the wheels, and fully tighten all 4 bolts for the channel guides.
Secure the sliding cargo box for transport with the retainer handles located on both ends. NOTE: BOTH
HANDLES MUST BE SECURED FOR TRANSPORT.
Releasing the handles on both sides will allow you to pull the cargo box outwards for easy access to your
gear. For safety concerns, the cargo box should pull outwards on the passenger side of the trailer.
MALONE AUTO RACKS 81 County Rd. Ste 1, Westbrook, ME 04092
P: 207.774.9100 F: 207.615.0551
E: support@maloneautoracks.com W: www.maloneautoracks.com
Limited Five (5) Year Warranty
The Malone Auto Racks (Malone) Limited 5 Year Warranty covers certain Malone-brand products that have been specically
identied for inclusion in the program. This warranty is in eect for ve (5) years, from the time of sale, for the original retail purchaser
of the product. This warranty is terminated after ve years from the date of purchase, or, when the original retail purchaser sells or
otherwise transfers the product to any other person or entity during the ve year warranty period.
Subject to the limitations and exclusions described in this warranty, Malone will remedy defects in materials and/or workmanship
by repairing or replacing, at its option, a defective product without charge for parts or labor. Malone may elect, at its option, not to
repair or replace a defective product but rather issue to the original retail purchaser a refund equal to the purchase price paid for the
product, or credit to be used toward the purchase of a replacement Malone product.
This warranty does not cover, and no warranty is given for defects or problems caused by normal wear and tear, which includes,
but is not limited to, surface (aesthetic) metal corrosion, scratches, dents, deformities, accidents, unlawful vehicle operation, or any
modication of a product not performed or authorized in writing by Malone.
In addition, this warranty does not cover problems resulting from conditions beyond Malone’s control including, but not limited to,
theft, misuse, overloading, or failure to assemble, mount or use the product in accordance with Malone’s written instructions or
guidelines included with the product provided to the original retail purchaser.
No warranty is given for Malone products purchased outside of the continental United States, Canada and Mexico.
If the product is believed to be defective, the original retail purchaser should contact the Malone dealer from whom it was purchased,
who will give the original retail purchaser instructions on how to proceed. If the original retail purchaser is unable to contact the
Malone dealer, or the dealer is not able to remedy the defect, the original retail purchaser should contact Malone by email at
In the event that the product must be returned to Malone, a technician at the email address above will provide the original purchaser
with return shipping instructions. The original purchaser will be responsible for the cost of mailing the product to Malone. In order
to be eligible to receive any remedy under this warranty, a copy of the original purchase receipt, a description of the defect and a
return address must be provided.
Disclaimer of Liability
Repair or replacement of a defective product, or the issue of a refund or credit (as determined by Malone) is the original retail
purchaser’s sole and exclusive remedy under this warranty. Damage to original purchaser’s vehicle, cargo, or property, and/ or to
any other person or property is not covered by this warranty.
This warranty is expressly made in lieu of any and all other warranties, express or implied, including the warranties of merchantability
and tness of a particular purpose
Malone’s sole liability to any purchaser is limited to the remedy set forth above. In no event will Malone be liable for any direct,
indirect, consequential, incidental, special, exemplary, or punitive damages , or, for any other damages of any kind or nature
(including but not limited to, lost prots, lost income or lost sales).
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations may not be
applicable.
In addition, all vehicular transports are potentially hazardous. Any person(s) using Malone products are personally responsible for
following the given directions for use and/or installation and accepts full responsibility for any and all damages or injury of any kind
including death, which may result from their use and/or installation.
MALONE
R
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Malone MPG537 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues