70mai A810 Manuel utilisateur

Marque: 70mai

Modèle: A810

Taper: Manuel utilisateur

70mai Dash Cam 4K A810 Series

User Manual

Service: [email protected]

Contents

This user manual has also been translated into Spanish, Portuguese, French, German, Hungarian,

Ukrainian, Korean, Vietnamese.

Scan the QR code to read the user manual with all supported languages.

Product overview

Note: Illustrations of the product, accessories, and user interface in the user manual are for reference purposes only. The actual product

and functions may vary due to product enhancements.

Please read this manual carefully before using the product and keep it in a safe place.

① Display

② Function buttons

③ Power button

④ Microphone

⑤ Ventilation holes

Mount

⑥ Indicator

⑦ Mount slot

⑧ Camera

⑨ Speaker

⑩ Rear camera port

⑪ Power port

⑫ Memory card slot

⑬ Adhesive sticker

6. Adjusting the camera angle

Turn on the dash cam and adjust the

camera angle based on the preview

screen.

1. Installing the

electrostatic sticker

Paste the electrostatic sticker

on the recommended area on

the front windshield. Press the

sticker to remove air bubbles

out.

Avoid the edge of the windshield and select the flat and

smooth area for the installation.

Note: Keep windshield clean and dry without liquid residue to

prevent the sticker from losing adhesion and dash cam from

dropping.

Installation

3. Installing the memory card

Insert the memory card into the card

slot.

2. Installing the mount

Attach the mount into the mount

slot and slide up.

4. Mounting the dash cam

Paste the dash cam onto the

electrostatic sticker.

5. Routing cable

Route the power cord to the

cigarette lighter and connect

power.

Notes:

• Use the included wiring trim tool to hide the power cord

underneath the vehicle's headliner and rubber seal along the

A-pillar.

• Depending on the vehicle, the cigarette lighter socket may

be located in a different position. The above figure is for

reference only.

Download 70mai app

This product may be used in conjunction

with the 70mai app. You can download and

install the app by scanning the QR code or

finding “70mai” in the app store.

Note: Android 4.4 & iOS 9.0 or above is required to connect to

the dash cam’s Wi-Fi hotspot with a mobile phone.

Accessories (optional)

The rear recording function of this product

needs to be used with the rear cameras.

Scan the QR code to obtain the operation

guide for rear camera.

Note: To avoide the rear camera malfunction due to device

incompatibility, it is recommended to use a rear camera from

70mai brand.

Online guide

For more on product functions and FAQs,

please see the user guide by scanning the

QR code.

Package contents

If you purchased the dash cam only, check the following

items in the package:

1. Dash Cam × 1

2. Mount × 1

3. Power cord × 1

4. Car charger × 1

5. Wiring trim tool × 1

6. Electrostatic sticker × 1

7. User manual × 1

If you purchased the Dash Cam Set, check the following

items in the package:

1. Dash Cam × 1

2. Mount × 1

3. Power cord × 1

4. Car charger × 1

5. Wiring trim tool × 1

6. Electrostatic sticker × 1

7. User manual ×1

8. Rear camera package* × 1

* This package contains the rear camera(integrated with lead

wire), signal wire and other accessories for the rear camera.

For more information about the rear camera, please refer to

the rear camera user manual.

Precautions

Before using this dash cam, please read all the precautions and the online guide to ensure correct and safe use.

• This dash cam is intended to assist drivers with the purpose of recording the environment outside the vehicle. The dash cam does not

guarantee the user's driving safety. We shall not be held liable for any accident, damage, or loss of information caused by operating

the dash cam while driving.

• Due to differences in vehicle conditions, driving style, driving environment, etc., some functions may not work properly. A power

failure, usage in environments outside the normal operating temperature or humidity range, a collision, or a damaged memory

Specifications

Product: Dash Cam

Model: A810, A810-2

Input: 5V 2A

Battery capacity: 500mAh

Resolution: 3840 × 2160

Memory card instructions

• A memory card (sold separately) must be installed in the dash cam before use.

• The dash cam supports standard MicroSD cards. Please use memory cards with the minimum capacity of 32GB and rating of

U3(UHS-3) or above.

• The default file partition format of the memory card may be inconsistent with the format supported by the dash cam. When inserting

the memory card for the first time, please format it in the dash cam before use. Formatting the memory card will delete all files on the

card. Please back up important data to another device beforehand.

• The memory card may become damaged or deteriorated after repeated cycles of overwriting, and this may affect its ability to save

video and image files. If this occurs, immediately replace it with a new memory card.

• Please use a high-quality memory card purchased from a reputable vendor. Inferior memory cards may have issues such as the actual

reading/writing speeds do not match the stated speeds, and the actual storage capacity does not match the stated storage capacity.

We shall not be held liable for lost or damaged videos caused by the use of a low-quality memory card.

• In order to avoid reading and writing speeds decreasing after prolonged use, it is recommended to format the memory card in the

dash cam every two weeks.

• Do not insert or remove a memory card while the dash cam is turned on.

Lens: FOV 150°/ F1.8

Battery type: Li-ion battery

Power supply: Car cigarette lighter

Wireless connectivity: Wi-Fi IEEE 802.11 b/g/n 2.4GHz

card may cause the dash cam to function abnormally. There is no guarantee that this dash cam will function normally under all

circumstances. Videos recorded by this dash cam are for reference only.

• Please install this dash cam correctly, and do not block the driver's line of sight, nor block the vehicle's airbag, in order to avoid

product failure or personal injury.

• Please use the included car charger, power cord, and other accessories in order to avoid product failure due to non-conformance. We

shall not be held liable for any loss or damage caused by the use of a non-genuine car charger or power cord.

• If the battery becomes deformed, swollen, or starts leaking during use or storage, stop using the dash cam immediately in order to

avoid safety issues, and contact after-sales service.

• Please keep this dash cam away from any strong magnetic fields, as they may cause damage to the dash cam.

• Do not use this dash cam in environments with temperatures over 60°C or below -10°C.

• Please only use this dash cam within the scope permitted by law.

Regulatory compliance information

WEEE information

All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should

not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over

your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed

by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the

environment and human health. Please contact the installer or local authorities for more information about the location as well

as terms and conditions of such collection points.

EU declaration of conformity

The manufacturer hereby, declares that this equipment is in compliance with the applicable Directives and European

Norms, and amendments. The full text of the EU declaration of conformity is available at the following internet address:

https://help.70mai.asia/1193.html

Cautions

• Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.

• Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of

flammable liquid or gas.

• A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

• This device is equipped with a built-in battery that cannot be removed or replaced. Do not disassemble or modify the battery by

yourself.

• Replacement of a battery with an incorrect type can defeat a safeguard (for example, in the case of some lithium battery types).

FCC

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the

equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired

operation.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be

installed and operated with a minimum distance of 20 cm between the radiator & your body. This transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter.

FCC ID: 2AOK9-A810

Hereby, 70mai Co.,Ltd. declares that the radio equipment types A810 and A810-2 are in compliance with Radio Equipment

Regulations 2017. The full text of the UKCA declaration of conformity is available at the following internet address:

https://help.70mai.asia/2145.html

Service: [email protected]

For further information, please go to www.70mai.com

Manufacturer: 70mai Co., Ltd.

Address: Room 2220, Building 2, No. 588, Zixing Road, Minhang District, Shanghai, China

ISED compliance statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s

licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement

économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:

(1) L’appareil ne doit pas produire de brouillage;

(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

ISED Radiation Exposure statement

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be

installed and operated with minimum distance 20 cm between the radiator and your body.

Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un environnement non contrôlé. Cet

équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.

IC: 28033-A810

V1.0-20221008

70mai A810 Manuel utilisateur

Marque: 70mai

Modèle: A810

Taper: Manuel utilisateur

Télécharger le PDF

rapport

dans d''autres langues

English: 70mai A810 User manual

70mai A810 Manuel utilisateur

70mai A810 Manuel utilisateur

dans d''autres langues

Documents connexes

Autres documents