Description

AutoConfiguration Adapter

The AutoConfiguration Adapters ACA11-... are devices for storing and updating configuration data

and software for the Hirschmann Industrial Ethernet devices

1)

.

In the case of a device failure, the ACA11-... enables a very simple configuration data transfer by

means of a substitute device of the same type.

Storing the current configuration data in the ACA11-...

You can transfer the current device configuration onto the ACA11-... and simultaneously onto the

Ord. code

943 751-001

ACA11 (EEC)

Ord. code

943 751-002

ACA11-miniDIN (EEC)

Ord. code

943 973-001

ACA11-M12 (EEC)

Ord. code

Plug the ACA11-... onto the V.24, the Mini-DIN or the M12 terminal of the device.

Note: When you restart, the device always assumes the configuration data of the ACA and saves

them permanently into the flash memory. Wether the configuration data of the ACA coincides with

the configuration data of the device, shows you the status of the AutoConfiguration Adapter in the

Web-based Interface or Command Line Interface.

Notes:

- The ACA11-... is intended for use and connection only to listed Hirschmann Industrial Ethernet

products providing Limited Power Source according to the EN 60950-1

requirements.

Maximum Electrical Ratings: U

: ± 15 V, I

Temperature Code: T4; Ta: 0 °C to +60 °C (standard) -or-

Temperature Code: T4; Ta: −40 °C to +70 °C for “EEC” and “(EEC)” types only (extended)

- refer to the type designation on the device.

Special conditions for safe use:

The ACA11-... modules must be installed in a suitable enclosure in accordance with EN60079-15,

taking into account the environmental conditions under which the equipment will be used.

Relevant Information for North America: Only for connection with a Class 2 power supply.

Max. surrounding air temperature:

+60° C max. - For “EEC” and “(EEC)” types only: +70° C max.

Additional Information for Use in Hazardous Locations (North America):

INDUSTRIAL CONTROL EQUIPMENT FOR USE IN HAZARDOUS LOCATIONS.

CLASS I, DIVISION 2, Groups A, B, C and D;

WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT UNLESS POWER

HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN TO BE NON - HAZARDOUS.

TO BE SUPPLIED BY A CLASS 2 POWER SUPPLY OR ISOLATED LOW VOLTAGE LIMITED

ENERGY (LVLE).

WARNING - EXPLOSION HAZARD - SUBSTITUTION OF ANY COMPONENTS MAY IMPAIR

SUITABILITY FOR DIVISION 2.

indicator.

In accordance with the above-named EU directive(s), the EU conformity declaration will be at the

disposal of the relevant authorities at the following address:

Hirschmann Automation and Control GmbH

Stuttgarter Str. 45-51

72654 Neckartenzlingen

Tel.: +49 1805 14-1538

Avertissement - Risque d'explosion - Ne pas débrancher tant que le circuit est sous tension à

moins que l'emplacement soit connu pour ne contenir aucune concentration de gaz inflammable.

Avertissement - Risque d'explosion - La substitution de tout composant peut rendre ce matériel

E-Mail: [email protected]

Internet: http://www.hirschmann.com

039 657-002-04-0415

Printed in Germany