9
SDB 2400 A1
GB
IE
Automatic switch-off
This steam iron is fi tted with an automatic switch-off
system. This stops the steam iron from heating up.
When the steam iron is resting on its sole and is not
moved for approx. 30 seconds, 6 warning beeps
will sound, "PAUSE" appears and the display 1
lights up red. After a few seconds, the display illumi-
nation 1 switches off . The steam iron will stop
heating up.
To deactivate the automatic switch-off , lift up the
steam iron and move it gently from side to side.
The display 1 lights up blue, the previously set
temperature level is shown and the steam iron
heats up again.
When the steam iron is resting on its base 7 and is
not moved for approx. 8 minutes, 6 warning beeps
will sound, "PAUSE" appears and the display 1
lights up red. After a few seconds, the illumination of
the display 1 switches off . The steam iron will stop
heating up.
To deactivate the automatic switch-off , lift up the
steam iron and move it gently from side to side.
The display 1 lights up blue, the previously set
temperature level is shown and the steam iron
heats up again.
NOTE
The automatic switch-off is not intended as a
substitute for r
emoving the plug from the mains
power!
It is merely designed to prevent the appliance
from overheating and helps to avoid unneces-
sary power consumption.
It does not, however, in itself provide fi re protec-
tion, for instance, if you place and leave the hot
steam iron on fl ammable material.
Cleaning
Self-cleaning function
1) Fill the water tank to the marking MAX.
2) Insert the plug into the mains power socket.
3) Set the temperature level to 9/MAX
4) Set the steam regulator 4 to maximum steam
power.
5) Allow the steam iron to heat up to the set
temperature.
6) Hold the steam iron horizontally over a catch-
ment receptacle.
7) Press and hold down the self-clean button 8.
Steam and boiling water fl ows from the steam exit
holes in the sole of the iron. Impurities that may be
present are washed out.
8) Release the self-clean button 8 as soon as all
of the water has run out.
9) Iron over a towel or old piece of material a few
times to dry the sole of the iron thoroughly.
10) Remove the plug from the mains power socket.
11) Allow the steam iron to cool down before
placing it in storage.
Housing
WARNING –
RISK OF ELECTRIC SHOCK!
► Always remove the plug from the mains power
s
ocket before cleaning the appliance.
► Never open the appliance housing! Otherwise
ther
e is a risk of a fatal electric shock.
WARNING – RISK OF INJURY!
► Allow the appliance to cool down before
cleaning it! Other
wise, there is a risk of burns!